📧 Email: info@legacyprohub.com | 📞 Call: 604-388-6687 / 672 206 0718 | 📞 Toll free: +1 855 205 9578
Recording Voiceover for Video Production With a Phone Microphone

Corporate video, explainers and social spots all need a clean voice track, and the microphone is rarely the bottleneck. A phone positioned correctly in a quiet room beats a condenser in an untreated office. What actually determines whether the voiceover is usable is noise floor, distance and consistency across takes.

What the edit needs from the recording

A voiceover is cut, compressed and mixed against music. That means it needs headroom, a low noise floor and consistent tone between takes. A recording that peaks at zero and sits in a reverberant room cannot be fixed in the edit, because the damage is baked into the file.

  • Peaks between -12 and -6 dB, never touching zero
  • Noise floor below -55 dB so silence does not hiss
  • Same distance and tone for every take

Room treatment on a budget

Stand in a wardrobe, sit under a duvet, or face a wall of curtains. The goal is to break up parallel hard surfaces within a metre of the microphone. This single step improves a phone recording more than any plugin, and it takes two minutes.

Environment Noise floor Verdict
Wardrobe with clothes -60 dB Best without a booth
Bedroom with curtains -52 dB Workable
Bare office -40 dB Audible room tone, hard to edit
Kitchen -35 dB Unusable for voiceover

Distance and angle

Hold the phone 15 to 20 cm from the mouth, slightly off axis so plosives miss the capsule. A stand is better than a hand: handling noise is the most common defect in phone voiceovers and it is entirely avoidable.

  • 15-20 cm, off axis by 20-30 degrees
  • Stand or shock mount, never hand-held
  • Pop filter is not needed at this distance if you speak across the capsule

Levels and monitoring

Set the input gain so normal speech peaks around -12 dB, then shout one word to confirm the limiter does not engage. Monitor with headphones, because laptop speakers hide rumble and plosives completely.

Stage Setting
Sample rate 48 kHz
Bit depth 24-bit if available, 16-bit acceptable
Speech peaks -12 dB
Shout test Must stay below -6 dB

Consistency across takes

Record three takes without moving the microphone. If the distance changes, the tone changes and the edit will need EQ matching that never sounds quite right. Mark the stand position with tape if you record across multiple sessions.

  • Tape the stand position
  • Same gain for every take
  • Record room tone for 10 seconds at the start

The chain into the edit

Record through the womic.io into any editor that writes uncompressed audio, then apply high-pass at 80 Hz, gentle compression at 3:1 and a limiter at -3 dB in the edit. Do not process destructively at capture; keep the raw file so the mix engineer can start over.

Frequently Asked Questions

Is a phone good enough for client video?

For corporate and social content, yes. For broadcast or cinema, no, but those productions supply their own audio chain.

Should I record in stereo?

No. Voiceover is mono. A single phone microphone recorded to one channel is exactly right.

How do I remove background hum?

Fix the source first, then high-pass at 80 Hz. A 50 or 60 Hz hum usually means a charger or a light dimmer nearby.

What about breathing sounds?

Turn your head slightly away on inhale rather than editing every breath out. Editing breaths is slow and often audible.

Scroll to Top